What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
12.06.2025 00:39

This device then solves the entire problem.
These are simplified answers to the original question, and does not change anything I wrote above.
The other is “what does a “fuse” do?”
In what ways is Bollywood becoming westernized?
nine
He then describes the function of a fuse.
This one hit behind the barn.
[image of Common-mode choke]
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
The bolt then partially travels down the line to your home.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
but this device (an Inductor) … impedes the rapid changes in the current.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Third case of bird flu detected at commercial farm in Maricopa County - ABC15 Arizona
There are two important concepts here.
It also is a device that limits the change in current flow.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
A fuse is a non-resetable over current circuit protector.
He then describes Rainy Season and Lightning.
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–14 [Omar Gharbi Omar Gharbi ]
This is where this question deviates from being a 'generic' question, and becomes more specific.
For this case there are devices called Metal oxide varistors (MOV).
CT scan radiation and cancer risk - reassuring and alarming at the same time - Daily Kos
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
An AC voltage/ current source, and an ac inductive load.
What does a fuse do?
No Man's Sky Gets A Massive Switch 2 Upgrade And It's All Free - Kotaku
So, the voltage could go up to 500 volts, and the fuse will not open up.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
How do I cope with the fact that I will never have a girlfriend?
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–10–10[John johnson John Johnson ]
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
How much of lounge pianists playing is from repertoire, and how much is improvised?
A circuit breaker is similar, but is resettable.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
but I think this circuit , shows a few more pieces.
Menopause Drug Reduces Breast Cancer Growth In Clinical Trial - ScienceAlert
a photo is worth a thousand words.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
But it can get overloaded, and no longer works.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
One is “what exactly is in a ‘surge protector’ ? ”
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
But… the neutral is now “floating” because of the 1 ohm resistance.
Now when you have a certain ac resistance, then a current flows in a loop.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
One
(Dc diagram shown, AC is similar).
This is the picture of an electronic coil of wire wound around a core of magnetic material.
At one ohm, the resistor has a maximum of 1 watt power.
Upvotes:
2024–10–16 [ OO OLAOYE OYEBODE ]
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
First Sentence:
[old diagram got deleted by accident]
In schematic diagrams this is the symbol for a fuse:
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Here is a simplified AC power diagram.
The third is lightning and “how it gets conducted into a home.”
Edit 2024–10.
What is lightning?
what exactly is a ‘surge’ protector?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
These devices are installed between the “hot” and “neutral” and protective ground.
There are three different concepts here that are getting confused.
the problem then depends on "how fast does the fuse operate?".
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
It seems Mohan does not understand the difference between a comment and an Answer.
I post the exact comment here.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
so, what happens?
eight
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Barnstars:
At least they know the answer if they wanted it.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This is 'the assistant's answer'
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
He then asserts :
This is where the MOV conducts again, and dissipated the energy.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).